![]() ![]() You could also hold you tile trowel with notches next to the straight edge or chalk line. ![]() I do this by resting either the chalk line or straight edge over the the area. Once you have marked out the dip, you will need to find out how deep it is. You might not be able to use a 4 ft level or straight edge if the area is too small for these to fit into. Once you find a bad area, it is a little easier to just slide the straight edge or level around and mark these areas out. I usually use the chalk line to find the bad areas and then use the straight edge to pin point the exact locations of where they begin and end. The only difference is, it will take longer to cover a bigger area. This is really going to be the same exact floor leveling strategy that we talked about above. Tip 2- Use at least a 4ft Level or Straight edge to find dips and humps If you do not have one, it can be rented for a reasonable price.ĭips can be filled with thin set and I have a super simple method for this. Humps can be ground down with a grinder(concrete) or belt sander(wood sub floor). ![]() If it’s a hump, then write that on the floor and the same goes for a dip. Just keep moving the chalk line around and mark the floor where these areas begin and end. Now you need to mark where the dip begins or where the hump begins. So what I mean is, if you see a dip when looking down the chalk line(and you might need to get your head down to the floor to really get a good look down the chalk line) then move to that area and shrink up the chalk line. Once you see where the problem areas are, you can then concentrate on those areas alone. The chalk line never lies and it will reveal all the problem areas to you. Now check to see where there are any dips and humps in the floor and continue to move the chalk line around the entire room. Stretch the chalk line out across the room, both ends should be held on the floor. Have someone help you with this by holding one end of the chalk line. Whether the room is 20 x 20 or 4 x 5 the methods are the same for floor leveling. Tip 1- Stretch out a chalk Line to find dips and humps
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |